106 RC435 and RC435i Chartplotters
To minimize these effects and to give you the best possible performance
from your Raymarine equipment, guidelines are given in the installation
instructions that enable you to ensure minimum interaction between
different items of equipment, that is, to ensure optimum Electromagnetic
Compatibility (EMC).
Always report any EMC-related problem to your nearest Raymarine
dealer. We use such information to improve our quality standards.
In some installations, it may not be possible to prevent the equipment
from being affected by external influences. In general this will not
damage the equipment but it can lead to spurious resetting action, or
momentarily may result in faulty operation.
6.2 Resetting the System
Two types of reset are available for the Chartplotter:
• Power-On Reset: When you turn the display unit off, then on again,
the screen reverts to the chart display with all windows cleared.
• Factory Reset: This resets all values back to their original factory
settings. The factory default settings are listed in Chapter 4.
Note: Take care–factory reset clears all Waypoint and Route data-
bases.
To perform a factory reset:
1. Power off the unit.
2. Press and hold CLEAR while powering up until <Erase backup
procedure> is displayed.
3. Either press CLEAR to abort Factory Reset and resume normal
Power-Up or press ENTER to continue Factory Reset.
4. Press ENTER again; the unit restarts as for a first time Power Up
with all values reset to their original factory settings.
To Next Page
Loading...
Need help?
General