Chapter 5: Operation 51
3. Select WAYPOINT LIST a nd press ENTER to display the Waypoint List.
The Waypoint List and associated function bar are displayed (see Fig-
ure 5-1 ).
The list details all waypoints. The selected waypoint is indicated by
the highlight bar with its position; bearing and range are provided (if
GPS fix available).
4. Use trackpad up/down to move through the list to highlight the
desired waypoint.
The selected waypoint can be edited using the EDIT WAYPOINT function.
Waypoint Data Display
Waypoint data can be viewed in two ways: the cursor can be used to select
the waypoint to display the waypoint data in the status bar at the top of the
screen, or the waypoint details can be viewed on the waypoint list.
➤ To display waypoint data:
Move the cursor over the waypoint. The waypoint data is displayed in the
status bar, indicating waypoint number/name, bearing and range from
vessel (dashes are shown if no fix is available).
While the cursor is over the waypoint, the WAYPOINT OPTIONS function
bar is displayed.
➤ To remove the waypoint data:
Move the cursor away from the waypoint or press CLEAR.
➤ To display the waypoint details from the waypoint list:
Select the waypoint in the list as described above.
The details for the selected waypoint are displayed in the lower half of the
window. Date and time are included for all waypoints where this
information was available when the waypoint was placed.
To remove the Waypoint List and return to chart mode, press CLEAR
three times.
To Next Page
Loading...
Need help?
General