Chapter 5: Operation 69
2. Select RESTART XTE. The dotted line between the original origin and
the target waypoint is redrawn from the vessel’s current position to
the target waypoint and the XTE is reset to zero
Going to an Individual Target
Rather than following a route, you can go directly to a selected target.
This can be an existing waypoint, a port or nearest facility or the current
cursor position.
Go to a Waypoint
To navigate directly to an existing waypoint:
1. From the normal chart display:
i. Use the trackpad to position the cursor over the desired waypoint
until the waypoint options function is displayed:
...then press ENTER to display the waypoint functions:
—or—
ii. Press the GOTO key to display the waypoint options and select
GOTO WAYPOINT; the waypoint list appears. Use the cursor to
select the desired waypoint:
D4689_1
STOP
GOTO
RESTART
XTE
D4718-1
D4672-1
To Next Page
Loading...
Need help?
General