Chapter 5: Operation 63
Editing a Route
A route may be edited in order to:
• Add a Waypoint into a route
• Remove a Waypoint from a route
• Move a Waypoint (as described in Section 5.2)
• Reverse a Route
Any changes made to the route affect only the current route, so the route
must be saved in order to keep the changes.
Inserting/Deleting Waypoints in a Route
➤ To add waypoint(s) to the end of a route:
Note: If no current route is displayed, select a route from the Route List
and use the SHOW ROUTE function to make it active, see Retrieving a
route from the database.
1. Select ROUTES then EDIT ROUTE and press ENTER; the PLACE WAY-
POINT function is displayed.
2. Add waypoint(s) to the route by moving the cursor and pressing
ENTER in the same way as the route was first created.
3. Remove waypoints from a route by pressing CLEAR in the same way
as the route was first created.
4. When your changes are complete, press the GOTO key to end route
editing.
5. Press CLEAR twice to return to chart mode.
Note: When deleting waypoints, if the route has not been saved, the way-
point is erased. If the route has been saved, the waypoint remains on the
screen.
➤ To insert a waypoint into a route:
1. Move the cursor over the route leg where a waypoint is to be inserted.
The route leg data is shown in the status bar and the ROUTE OPTIONS
function, with help text, is displayed:
To Next Page
Loading...
Need help?
General