Software application 990 REINER PCset 31
ERNST REINER GmbH & Co. KG Originalanleitung
5.4 Establishing Bluetooth connection
To establish a Bluetooth connection, Bluetooth must be activated on the device
(see "Activate Bluetooth").
Opening the REINER PCset.
In the menu bar select the "File" tab and click "Search for REINER Bluetooth
devices".
An automatic search is started.
All devices found, as well as all devices that have already been connected to the REINER
PCset, are displayed with model and serial number.
If the jetStamp 990 is not found, a new search run can be started with the "Search again"
button.
Note that Bluetooth must be activated on the device for this!
The status line in the device must show "BT" for this.
To establish the Bluetooth connection, select the corresponding device in the list and click
"Connect".
A pop-up menu "Connection via Bluetooth device" opens in the Windows status bar.
After a short time the jetStamp 990 is connected to the REINER PCset.
The connected device is saved as a permanent connection so that the REINER PCset always
connects to this device as soon as it is available.
When REINER PCset is connected to the jetStamp 990, the device display shows BTC.
To cancel the permanent connection, click the "Delete pre-set device" button in the Bluetooth
dialogue or establish a connection with another device.
To Next Page
Loading...
Need help?
General
