• If the network interface board is not installed properly, repeat the entire installation procedure. If you
cannot install it properly even after attempting reinstallation, contact your sales or service
representative.
• Dispose of the removed component as general plastic waste or hand it in for collection.
Attaching the Paper Feed Unit TK1060
• The machine weighs around 19.2 kg (42.4 lb) (28 kg (61.8 lb) with options installed).
• To
avoid injury to self and damage to the machine, lift the machine slowly and carefully by gripping
the central areas near the base on both sides. When lifting the machine with options attached, have
at least one other person assist you.
• Careless handling and over exertion when lifting can result in breakage and/or injury.
1. Make sure the printer's power cord is unplugged.
2. Take the paper feed unit out of its box.
3. Position the paper feed unit close to the printer.
4. Remove the orange tape from the paper feed unit.
5. Attach the paper feed unit cover to the paper feed unit.
6. Align
the connecting parts of the printer and paper feed unit, and then lower the printer onto
the paper feed unit.
Always lift and carry the printer with another person. Grip the indented area at the base of the printer's
sides, as shown. Lift and carry the printer slowly and carefully.
Setting Up the Hardware
37
To Next Page
Loading...
Need help?
Power
Printing Specifications
Paper Handling
Weight and Dimensions
