System Settings
72
2
I Press the {User Tools/Counter} key.
Programming the LDAP server
This section describes how to specify the LDAP server settings.
To enter an identification name
This section describes how to enter a identification name.
A Press [Change] under "Identification Name".
Register a name for the LDAP server that will appear on the server selection
screen of the LDAP search operation.
B Enter the server’s identification name.
C Press [OK].
To enter a server name
This section describes how to enter a server name.
A Press [Change] under "Server Name".
Register the LDAP server’s host name or IP address.
B Enter the LDAP server name.
C Press [OK].
To enter the search base
This section describes how to enter the search base.
A Press [Change] under "Search Base".
Select a route folder to start the search from e-mail addresses registered in the
selected folder are search targets.
B Enter the search base.
For example, if the search target is the sales department of ABC company, en-
ter “dc=sales department, o=ABC”. (In this example, the description is for an
active directory. “dc” is for the organization unit, and “o” is for the company.)
Search base registration may be required depending on your server environ-
ment. When registration is required, unspecified searches will result in error.
Check your server environment and enter any required specifications.
C Press [OK].
To Next Page
Loading...
Need help?
General
