4. Press [Reserve Start].
The machine starts scanning the placed original.
After the current copy job is completed, the reserved copy job starts automatically.
• To delete the reserved job or preview its image on the screen, press [Job Confirmation].
Interrupting the Current Copy to Copy Another Original
When [Interrupt] is displayed on the copy processing screen, you can pause the current copy to scan
and copy another original (Interrupt mode).
1. Press [Interrupt] on the execution screen of a copy job.
2. When the scanning stops, remove the original being copied.
3. Place a new original to scan on the machine.
page 71 "Basic Procedure for Copying Documents"
4. Specify 2 sided, Combine, Sort, and other copy settings if necessary.
page 82 "Duplex Copying"
page 84 "Combining and Copying a Multi-page Original onto a Single Sheet of Paper"
page 90 "Copying in Page Order or for Each Page Number"
5. Press [Interrupt Start].
6. When the Interrupt mode is finished, remove the original and copied paper.
7. Press [Cancel Interrupt].
8. Set the rest of the original that was supposed to be copied before the Interrupt mode, and
press [Start].
The previous copy job settings are restored. Simply press [Start] to continue copying from where it
left off.
• You cannot use the Interrupt mode while scanning a fax original.
Basic Procedure for Copying Documents
75
To Next Page
Loading...
Need help?
General
