When a Message Is Displayed While Using the
Fax Function
• When confirming or changing the settings in [Settings], press [Home] ( ) after closing [Settings].
Messages Displayed During Operation or When Sending/Receiving a Fax
Cannot Be Performed
Message Condition Solution and reference
"Cannot detect original
size."
An original is not placed
correctly on the
machine.
Place the original correctly. When you place
an original on the exposure glass, the machine
detects the original size by opening and
closing the ADF. Open the ADF by more than
30 degrees when placing an original.
An original with a
difficult-to-detect size,
even in the regular size,
such as a transparency
or paper with sticky
notes or a custom size
original, is placed on
the machine.
Specify [Scan Size] in [Settings].
"Error occurred, and
transmission was
cancelled."
An original had jammed
while sending a fax.
Press [Confirm], remove the jammed original,
and then send the fax again.
An error occurred
temporarily in the
machine, or there was
interference on the line
such as excessive noise
or cross-talk.
Press [Confirm] and send the fax again.
"Memory is full. Cannot
scan more. Transmitting
only scanned pages."
The memory is full. Press [Confirm] to return to the stand-by state
and start sending the pages that are already
scanned and stored. Check the transmission
result report for unsent pages, and send those
pages later.
When a Message Is Displayed While Using the Fax Function
185