Cleaning the Registration Roller
If the registration roller is dirty, a misfeed might occur. In this case, clean the roller as follows:
• Be sure to turn off the power switch and wait for about 15 minutes before cleaning the Registration
roller. Not waiting for the printer to cool down can result in a burn.
• The inside of this printer becomes very hot. Do not touch parts labeled " " (indicating a hot
surface). Touching these parts will result in burns.
Clean the registration roller if dots (caused by specks of paper stuck to the roller) appear on printed OHP
transparencies.
• Do not hold the toner cartridge upside down or stand it vertically.
• Do not put the toner cartridge on an unstable or tilted surface.
• Do not use chemical cleaners or organic solvents such as thinners or benzine.
1. Turn off the power, and then unplug the power cable.
2. Open the front cover by pushing the front cover release button.
Cleaning the Registration Roller
157
To Next Page
Loading...
Need help?
General
