Installing the Memory Expansion Units
• Do not touch the inside of the controller board compartment. Doing so may cause a printer
malfunction or a burn.
Installing the Hard Disk
• Before touching the hard disk, touch something metal to discharge any static electricity. Static electricity
can damage the hard disk.
• Do not subject the hard disk to physical shocks.
• Before using the new hard disk, be sure to make the settings in the printer driver.
1. Check the package contains the following:
1. Hard disk
2. Screws
2. Turn off the power of the printer, and then unplug the power cable and interface cable.
3. Remove the two screws holding the controller board in place.
2. Installing Options
34
To Next Page
Loading...
General
