Rigol DSG800 Series User Manual

RIGOL Chapter 2 Front Panel Operations
2-10 DSG800 User's Guide
ramp waveform.
Triangle: the sweep period always starts from the start frequency or start
level to the stop frequency or stop level and then returns back to the start
frequency or start level. The sweep sequence is similar to a triangle
waveform.
Sweep Mode
Press SWEEP  Mode to select "Cont" or "Single" sweep and the default is "Cont".
 Cont: when continuous sweep is selected, the continuous sweep label is
displayed in the frequency or amplitude area in the user interface. When the
trigger condition is met, the instrument sweeps continuously according to the
current setting.
 Single: when single sweep is selected, the single sweep label is displayed in the
frequency or amplitude area in the user interface. When the trigger condition is
met, the instrument performs a single sweep according to the current setting
and then stops.
Single Sweep
If the current sweep mode is "Cont", press Single to switch the sweep mode to
"Single" and the instrument will perform a single sweep if the trigger condition is
met.
If the current sweep mode is "Single", press Single and the instrument will perform
a single sweep if the trigger condition is met.
To Reset the Sweep
If the current sweep direction is "Fwd", press Reset Swp, the instrument stops the
current sweep and restarts the sweep from the start frequency or start level.
If the current sweep direction is "Down", press Reset Swp, the instrument stops the
current sweep and restarts the sweep from the stop frequency or stop level.
w ww. . com
information@itm.com1.800.561.8187

Rigol DSG800 Series Specifications

General

Brand	Rigol
Model	DSG800 Series
Category	Portable Generator
Language	English