RIGOL Chapter 3 Remote Control
3-2 DSG800 User's Guide
Remote Control Overview
DSG800 supports to build communication with the PC via the USB or LAN interface to
realize remote control. The remote control is realized on the basis of the SCPI
(Standard Commands for Programmable Instruments) command set. The remote
control is realized in the following two modes.
1. User-defined programming
Users can program and control the RF signal generator using the SCPI
commands on the basis of NI-VISA (National Instrument-Virtual Instrument
Software Architecture) library. For the detailed information of the commands
and programming, refer to
DSG800 Programming Guide
.
2. Use PC software
Users can use the common PC software (Ultra Sigma) provided by RIGOL to
send SCPI commands to control the RF signal generator remotely.
This chapter will give a detailed introduction of how to use Ultra Sigma to control the
RF signal generator remotely through the USB and LAN interfaces. After acquiring
the Ultra Sigma software, install it as well as the desired components according to
the corresponding help document. This software is contained in the resource CD in
the standard accessories. You can also download the latest version of the software
from
www.rigol.com.
Note: When the instrument is in remote mode,
is displayed in the user
interface and all the front panel keys (except ESC) are locked. At this point, you can
press ESC to exit the remote mode.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
