RIGOL Chapter 4 Application Examples
4-4 DSG800 User's Guide
3. Turn on the RF sweep
Press SWEEP Sweep and select "Freq & Lev" to turn on the frequency and
amplitude sweep functions at the same time.
At this point, the RF signal generator sweeps from the start frequency and level
to the stop frequency and level continuously at certain step according to the
current settings. The frequency and amplitude sweep progress bars as well as
the continuous sweep label are displayed in the frequency and amplitude areas
in the user interface respectively; in addition, the Sweep label in the function
status area is illuminated.
4. Turn on the RF output
Press RF/on; the backlight of the key and the RF label displayed in the function
status area in the user interface are illuminated. At this point, the RF output is
turned on and the [RF OUTPUT 50Ω] connector outputs RF sweep signal
according to the current configuration.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
