Publication 2711C-UM001C-EN-P - September 2009 89
Troubleshoot the System Chapter 6
POST errors are fatal and most likely due to failed hardware. A fatal
error during firmware installation and loading is most likely
recoverable by installing the appropriate firmware.
Interpret the Status Indicators at Startup
The C600 and C1000 terminals have indicators on the back of the unit
to isolate operating problems.
• Comm indicator for communication
• Fault indicator for hardware faults
Firmware Installation and Loading
Message State Code
Load Firmware Image into RAM Update 1E
Write Firmware Image into Flash Update A5
Complete and Successful Firmware Installation Update OK
Firmware Image Validation (CRC/Format) Failure Fatal 1E
Firmware Image Compatibility Failure Fatal 1F
Firmware Write to Flash error Fatal A5
Firmware Read-After-Write Verify Fatal D2
Invalid or missing Firmware Image Fatal 0A
Other Commonly Observed Status Codes
Message State Code
Boot Loader connects to PC via USB Device AutoTest 0A
Boot Loader loads Firmware Image into RAM AutoTest E6
Boot Loader jumps to Operating System AutoTest FF
Operating System start up Boot G0
Operating System Initialize Init I1…J0
Application Registration and Initialize Init N1…N3
Application Load and Execute Load N4…N6
To Next Page
Loading...
Need help?
General
