Publication 2711C-UM001C-EN-P - September 2009 125
Firmware Update Utility Appendix D
Resolve Firmware Upgrade
Issues
If you experience problems with the firmware update utility, check
that your USB RNDIS adapter settings are correct.
1. Open the Windows Network Connections folder
2. Reset the Terminal.
3. Right-click the connection with name Allen-Bradley PanelView
Boot Loader USB Remote RNDIS Network Device when it
appears, then select Properties. Note that this connection will
disappear after a few seconds) .
TIP
Momentarily open the USB connection at the same time
power is cycled. Otherwise, the power from the USB
connection may prevent the terminal from resetting.
To Next Page
Loading...
Need help?
General
