98 Publication 2711C-UM001C-EN-P - September 2009
Appendix B Adding Font Files
5. Select Font as the file type and click Next.
6. Click Browse … to locate and select the Font file, then click
Open.
7. Select Internal Storage as the destination for the font file and
click Transfer.
8. Observe the informational message for Transferring File.
9. The terminal should be rebooted to load the added font and
make it available to the design environment.
Remove a Font File
A font that was added to the terminal and is no longer used can be
removed. Follow these steps to remove a font from the terminal.
1. Open the PanelView Explorer Startup window.
2. Click File Transfer.
3. Click Delete File.
4. Select the source location of the Font file, typically Internal
Storage, and click Next.
5. Select Font as the file type and click Next.
Observe the list of all Font files that have been added to the
Terminal.
6. Select the Font file that you want to delete and click Delete.
7. Observe the Confirmation message for the selected Font file and
click OK.
8. Observe the informational message Deleting File.
9. Observe the deleted font file no longer appears in the list of all
Font files.
ATTENTION
If importing a font to the emulator internal storage, you need to
Flash Save for it to be permanently stored in emulator.
Otherwise, it’s lost once you shut down. To save to internal
storage, select Flash and then Save from the Emulator’s main
window menu.
To Next Page
Loading...
Need help?
General
