Siemens SIMATIC HMI TP1900 Comfort User Manual

Commissioning a project
5.7 Updating the operating system
Comfort Panels
Operating Instructions, 07/2017, A5E36770603-AB
167
5.7
Updating the operating system
5.7.1
Updating the operating system
Introduction
If the operating system version of an HMI device is not compatible with the configuration, you
need to update the operating system of the HMI device. Depending on the protocol used, the
operating system on the HMI device is updated automatically upon prompting when the
project is loaded. Thereafter, the loading continues. Otherwise, the loading of the project is
canceled. In this case, you have to start the update of the operating system manually.
Updating the operating system
To update the operating system of an HMI device, connect the HMI device to the
configuration PC. If possible, use the interface with the highest bandwidth, such as Ethernet,
to make this connection.
"Reset to factory settings"
If the operating system on the HMI device is no longer functional, update your operating
system and restore the factory settings on the HMI device. If the HMI device detects the fault
itself, the HMI device automatically restarts in "bootstrapping" mode and issues a
corresponding message.

Siemens SIMATIC HMI TP1900 Comfort Specifications

General

Brand	Siemens
Model	SIMATIC HMI TP1900 Comfort
Category	Control Panel
Language	English