Commissioning the device
4.3 Parameter assignment for Comfort Panel
Comfort Panels
86 Operating Instructions, 07/2017, A5E36770603-AB
Setting the character repeat rate of the screen keyboard
You can use this function to set the character repeat and repeat delay for the screen
keyboard.
The Control Panel is open.
1. Open the "Keyboard Properties" dialog using the "Keyboard" icon.
Check box for selecting the character repeat
Slider control and buttons for the delay time before character repeat
Slider control and buttons for the rate of the character repeat
2. If you want to enable character repetition, select the "Enable character repeat" check box.
3. To change the delay, press a button or the slider in the "Repeat delay" group.
Moving the slider to the right reduces the delay. Moving it to the left extends the delay
time.
4. To change the repeat rate, press a button or the slider in the "Repeat rate" group.
Moving the slider to the right speeds up the repeat rate. Moving to the left will slow down
the repeat rate.
5. Check the settings for the touch control by touching the test field.
The screen keyboard is displayed.
6. Move the screen keyboard as needed.
7. Press a key for a character and keep the key pressed.
Check that character repetition occurs and the rate of the character repetition in the test
field.
8. If the settings are not ideal, correct them.
9. Confirm your entries with "OK".
The dialog closes.
The character repetition and delay are set.
To Next Page
Loading...
Need help?
General
