Configuring with Web Based Management
4.4 "System" menu
SCALANCE SC-600 Web Based Management (WBM)
208 Configuration Manual, 10/2021, C79000-G8976-C475-03
4.4.15 Fault monitoring
4.4.15.1 Power supply
Settings for monitoring the power supply
Configure whether or not the power supply should be monitored by the messaging
system. With a redundant power supply, configure the monitoring separately for each
individual feed-in line.
A fault is then signaled by the message system when there is no power on one of the
monitored lines (line 1 or line 2) or when the voltage is too low.
Note
You will find the permitted operating voltage limits in the compact operating instructions
of the device.
A fault causes the signaling contact to trigger and the fault LED on the device to light up
and, depending on the configuration, can trigger a trap or an entry in the event log table.
Procedure
1. Click the check box in front of the line name you want to monitor to enable or disable
the monitoring function.
2. Click the "Set Values" button.
To Next Page
Loading...
Need help?
General