Description of system components
8.3 Operator panel with display
SIMOCODE pro
116 System Manual, 05/2019, A5E40507475002A/RS-AD/004
● T1, T2, T3
6)
Shows the individual temperatures of all used sensor measuring circuits of the
temperature module 1 in °C (can be switched to °F).
● T1, T2, T3
6)
Shows the individual temperatures of all used sensor measuring circuits of the
temperature module 2 in °C (can be switched to °F).
● Thermal motor model
Shows the current temperature rise of the internal thermal motor model in %.
● Time to trip
Shows the estimated time to trip.
● Cooling down period
Displays the cooling down period remaining before the motor can be switched on again
after an overload trip.
● Last trip current
Shows the magnitude of the current that was measured at the moment of the overload
trip, unit of measurement can be switched between A and % of I
s
.
1) Possible only if a current measuring module or current / voltage measuring module is
used
2) Possible only if a current / voltage measuring module is used Values will only be displayed
if phase voltage is set/configured
3) Possible only if a current / voltage measuring module is used and line-to-line voltage is
set/configured
4) Possible only if a current / voltage measuring module is used
5) Possible only if the analog module is used
6) Possible only if the temperature module is used
7) 2nd generation current / voltage measuring module necessary
To Next Page
Loading...
Need help?
General
