Technical data
15.6 Technical data of the expansion modules
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
349
15.6.3 Technical data of the DM-F Local digital module
Technical data of the DM-F Local digital module
"READY"
System interface not connected / supply voltage too low / device defective
Device ON/system interface OK
Device ON / system interface not active or not OK
"DEVICE"
Device defective or faulty
"OUT"
Safety-related output not active
Safety-related output active
Feedback circuit not closed although start condition satisfied
"IN"
Fault detected (e.g., cross circuit at input, sensor simultaneity not fulfilled)
"GF"
Group fault (wiring error, cross-circuit, configuration error)
Group fault (feedback circuit fault, simultaneity condition not satisfied)
"1"
Cross-circuit detection Off
Cross-circuit detection On
Configuration mode waiting for confirmation
"2"
Yellow NC contact/NC contact
Flashing yellow Configuration mode waiting for confirmation
"3"
Configuration mode waiting for confirmation
"4"
Debounce time Y12, Y22, Y34 ~ 50 ms
Debounce time Y12, Y22, Y34 ~ 10 ms
Configuration mode waiting for confirmation
"5"
Sensor circuit, automatic start
Sensor circuit, monitored start
Configuration mode waiting for confirmation
To Next Page
Loading...
Need help?
General
