Description of system components
8.3 Operator panel with display
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
115
8.3.3.4 Display of measured values in the measured values display
The "Measured Values" menu item displays all current SIMOCODE pro measured values.
Depending upon the type of expansion modules used, all or only some of the values listed
here will be available. These are the most important menus by way of example:
● Imax
1)
Shows the maximum current of all three phases and can be switched between A or %
of I
s
● IL1, IL2, IL3
1)
Shows the currents of all three phases and can be switched between A or % of I
s
.
● Phase unbalance
1)
Shows the current phase unbalance as a percentage.
● UL1-N, UL2-N, UL3-N
2)
Shows all phase voltages in V.
● U L1-L2, U L2-L3, U L3-L1
3)
Shows all line-to-line voltages in V.
● Cos phi, P, S
4)
Shows the power factor (0 to 100 % or absolute, switchable using the right softkey), the
active power in kW, and the apparent power in kVA.
● Frequency [Hz]
7)
● Ground-fault current [mA]
Shows the measured value of the residual current.
● Last trip current [mA]
Shows the last measured value of the residual current.
● Analog input 1, analog input 2, analog output (for AM1)
5)
Shows the current values at both inputs and the actual value at the output of analog
module 1 and can be switched over between mA and %.
● Analog input 1, analog input 2, analog output (for AM2)
5)
Shows the actual values at both inputs and the actual value at the output of analog
module 2 and can be switched over between mA and %.
● Max. temperature
6)
Shows the maximum temperature of all used sensor measuring circuits of the
temperature module 1 in °C (can be switched to °F).
● Max. temperature
6)
Shows the maximum temperature of all used sensor measuring circuits of the
temperature module 2 in °C (can be switched to °F).
To Next Page
Loading...
Need help?
General
