Siemens SIMOCODE pro V EIP User Manual

Description of system components
8.14 Configuration information for SIMOCODE pro V when using an older basic unit
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
155
8.14 Configuration information for SIMOCODE pro V when using an older
basic unit
Note
Restrictions for the SIMOCODE pro V device series
The restrictions mentioned here apply to the SIMOCODE
pro V High Performance device
ser
ies with the following product versions:
•
SIMOCODE pro V PB: Before E15
•
SIMOCODE pro V PN: Before E10
•
SIMOCODE pro V MR: Before E03
Devices with the stated product versions or later can b
e used without restriction with an
operator panel with display
and 2nd generation current/voltage measuring modules.
You will find usage restrictions concerning the operator panel with display in Chapter
Description of the operator panel with display (Page 88).
Use of a decoupling module and/or an operator panel with display
If you want to use an operator panel with display and/or a decoupling module in the
SIMOCODE pro V system, then the following configuration instructions concerning the type
and number of connectable expansion modules must be observed.
The following table shows the maximum possible configuration with expansion modules for
the various combinations (✓ = possible, - = not possible):

Siemens SIMOCODE pro V EIP Specifications

General

Brand	Siemens
Model	SIMOCODE pro V EIP
Category	Control Unit
Language	English