Siemens SIMOCODE pro Operating Manual

Parameters
4.3 Monitoring functions
SIMOCODE pro - Parameterize
152 Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
4.3.7.2
Operating hours monitoring
Motor operating hours monitoring - use
The motor operating hours monitoring function enables the operating hours (service life) of a
motor to be recorded so that motor maintenance prompts can be generated in good time as
applicable.
Level
If the operating hours exceed the set response level, the monitoring function responds.
Level
0 to 1193046 hours (default: 0 h)
Active status
Unless deactivated, this function is always active, independent of whether the motor is
running or not (operating state "ON").
Response
You can define the response to overshoot here.
See also "Tables of responses of SIMOCODE pro" in Chapter Important information
(Page 7) and Table "Responses" in Chapter Description of functions of operation monitoring
(Page 150).

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000