Parameters
4.3 Monitoring functions
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
155
You can define the response to overshoot of the number of starts within the time range for
starts here:
See also "Tables of responses of SIMOCODE pro" in Chapter Important information
(Page 7) and Table "Responses" in Chapter Description of functions of operation monitoring
(Page 150).
You can define the response after the penultimate start here.
See also "Tables of responses of SIMOCODE pro" in Chapter Important information
(Page 7) and Table "Responses" in Chapter Description of functions of operation monitoring
(Page 150).
If a new start command is issued within the time range for starts after the last permissible
start, this new start command will no longer be executed if the setting "Response to
overshoot - tripping" has been set. "Fault - No. of starts >" will be displayed and the set
interlocking time activated.
00:00:00 to 18:12:15 hh:mm:ss (default: 00:00:00)
To Next Page
Loading...
Need help?
General
