Parameters
4.2 Motor control
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
63
Control function schematic
The following schematic shows a general view of the control function ("Protection/Control"
function block):
Figure 4-10 "Protection/Control" function block
**) See also Chapter Motor protection (Page 31)
The QE contactor controls are switched dependent on the incoming control commands and
taking the specified control function into consideration including all corresponding interlocks,
feedbacks, corresponding parameters and the higher-level motor protection. In general, the
QE contactor controls are directly connected to the outputs of the basic unit or the digital
modules and switch the connected contactors using relays. The number of usable QE
contactor controls is directly dependent on the set control function.
To Next Page
Loading...
Need help?
General
