4.2.3 Storage
Storing indoors
• Apply a preservation agent (e.g.Tectyl) to bare external motor components if this has not
already been carried out in the factory.
• Store the motors as described in Section "Ambient conditions for long-term storage and
transport". The storage room/area must meet the following conditions:
– Dry
– Dust-free
– Free of vibration
– Well ventilated
– Protected against extreme weather conditions
– The air inside the room or space must be free of any aggressive gases
• Protect the motor against shocks and humidity.
• Make sure that the motor is covered properly.
Protection against humidity
If a dry storage area is not available, then take the following precautions:
• Wrap the motor in humidity-absorbent material. Then wrap it in foil so that it is air tight.
• Include several bags of desiccant in the sealed packaging. Check the desiccant and replace
it as required.
• Place a humidity meter in the sealed packaging to indicate the level of air humidity inside it.
• Inspect the motor on a regular basis.
Protecting the cooling system for motors with integrated cooling
Before you store the motor after use, perform the following actions:
• Empty the cooling channels.
• Blow out the cooling ducts with dry, compressed air so that the cooling ducts are completely
empty.
• Seal the connections of the cooling system.
Preparation for use
4.2Transporting and storage
1FW6 built-in torque motors
64 Operating Instructions, 09/2022, A5E52220812B AA
To Next Page
Loading...
Need help?
General