TC35i AT Command Set
10. FAX Commands
s
m
obil
e
TC35i_ATC_V02.07 Page 243 of 439 1/30/04
Confidential / Released
10. FAX Commands
The following commands can be used for FAX transmission. If the ME is acting as a Fax-Modem to a PC-based
application (e.g. "WinFax") it is necessary to select the proper Service Class (Fax Class) provided by the ME.
The ME reports its Service Class capabilities, both the current setting and the range of services avaible. This is
provided by the
AT+FCLASS command.
Service Classes supported by ME:
The following AT commands are dummy commands:
AT+FAA Auto Answer mode
AT+FECM Error Correction Mode control
AT+FLNFC Page Length format conversion
AT+FLPL Indicate document available for polling
AT+FMINSP Minimum Phase C speed
AT+FRBC Phase C data receive byte count
AT+FREL Phase C received EOL alignment
AT+FSPL Enable polling
AT+FTBC Phase C data transmit byte count
AT+FWDFC Page width format conversion
Invoking these commands will not cause ERROR result codes, but these commands have no functionality.
10.1 FAX parameters
Parameter Description
Binary File Transfer Mode
Note: Only the default value needs to be implemented. Use test command to check which parameter values are
really possible!
[0] disable BFT
1 enable BFT
Bit Rate
0 2400 bit/s, V.27ter
1 4800 bit/s, V.27ter
2 7200 bit/s, V.29
[3] 9600 bit/s, V.29
AT+FCLASS Parameter Service class Reference, Standard
0 data modem e.g. TIA/EIA-602 or ITU V.25ter
1 Service Class 1 EIA/TIA-578-A
2 manufacture specific this document and EIA PN-2388
(draft)
<bf>
(num)
<br>
(num)
To Next Page
Loading...
Need help?
General
