Siemens TC35i User Manual

TC35i AT Command Set
3. Status Control Commands
s
m obil e
TC35i_ATC_V02.07 Page 61 of 439 1/30/04
Confidential / Released
3. Status Control Commands
The AT Commands described in this chapter allow the external application to obtain various status information
from the TC35i.
3.1 AT+CMER Mobile Equipment Event Reporting
This command controls details of the "+CIEV" URC presentation related to AT^SIND and AT+CIND. If registered
via these commands the URCs are sent whenever a value of the related indicator changes.
After
AT+CMER has been switched on, URCs for all registered indicators will be issued.
Syntax
Test Command
AT+CMER=?
Response(s)
+CMER: (list of supported<mode>s), (list of supported<keyp>s), (list of supported<disp>s), (list of
supported
<ind>s), (list of supported<bfr>s)
OK
Read Command
AT+CMER?
Response(s)
+CMER: <mode>, <keyp>, <disp>, <ind>, <bfr>
OK
Write Command
AT+CMER=[<mode>[, <keyp>[, <disp>[, <ind>[, <bfr>]]]]]
Response(s)
OK
ERROR
+CME ERROR
PIN ASC0 MUX1 MUX2 MUX3
% % % % %
Reference(s)
GSM 07.07

Siemens TC35i Specifications

General

Brand	Siemens
Model	TC35i
Category	Modem
Language	English