TC35i AT Command Set
11.23 AT^SMGL
s
m
obil
e
TC35i_ATC_V02.07 Page 316 of 439 1/30/04
Confidential / Released
11.23 AT^SMGL List SMS messages from preferred store without set-
ting status to REC READ
Syntax
Command Description
The execute command is the same as the write command, but uses the given default of <stat>.
The write command allows to select a status type and lists, from the message storage
<mem1>, all messages
that currently have the specified
<stat>. The major difference over the standard command AT+CMGL is that the
status of the listed messages remains u n c h a n g e d (unread remains unread).
Notes
• The selected <mem1> can contain different types of SMs (e.g. SMS-DELIVERs, SMS-SUBMITs, SMS-STA-
TUS-REPORTs and SMS-COMMANDs), the response may be a mix of the responses of different SM types.
TE application can recognize the response format by examining the third response parameter.
• This command can be used only after the SMS data from the SIM have been read successfully for the first
time. Reading starts after successful SIM authentication has been performed, and may take up to 30 seconds
depending on the SIM used. While the read process is in progress, an attempt to use any of the sms read
commands will result in ''+CME Error: 14'' (SIM busy)
Test Command
AT^SMGL=?
Response(s)
same as AT+CMGL
Exec Command
AT^SMGL
Response(s)
^SMGL: (For default values of <stat>, see Chapter "SMS parameters.)
OK
Write Command
AT^SMGL=<stat>
Response(s)
same as AT+CMGL
PIN ASC0 MUX1 MUX2 MUX3
% % % % %
Reference(s)
SIEMENS
To Next Page
Loading...
Need help?
General
