7 Transmission Repair
7B Eaton 750 / 751
7 - 32
Figure B–81. Install Gasket and Wear Plate
10. Install the wear plate, bowed side toward the motor
rotor assembly, aligning it with the two dowels.
11. Install the second of three gaskets on the wear plate,
aligning it with the dowels.
Figure B–82. Install Ring Gear Assembly
12. Install the ring gear assembly on the transaxle hous-
ing, aligning it with the brake shaft and dowels.
NOTE: The two ring gear assemblies are identical and
can be installed on either side of the housing assembly.
However, when installing the ring gear assembly, the
side with the needle bearing must face the axle housing
assembly (toward outside, as shown) for additional sup-
port.
Figure B–83. Assemble Primary Carrier Assembly
13. Lubricate and assemble the three planetary gears on
the primary carrier assembly.
Figure B–84. Install Primary Carrier Assembly
14. Install the primary carrier assembly into the ring gear
assembly by aligning and engaging it with the previ-
ously installed sun gear.
NEEDLE
BEARING
To Next Page
Loading...
Need help?
General
