7 Transmission Repair
7C Tuff Torq K60
7 - 52
12. Remove the final pinion assembly.
Figure C–26. Remove Final Pinion Assembly
13. Remove the three capscrews and magnet from the
center case assembly.
NOTE: Clean the magnet by blowing clean with com-
pressed air. Eye protection must be worn when using
compressed air to prevent personal injury.
NOTE: Use care when removing the center case to pre-
vent damage to the center case and the cylinder blocks.
Figure C–27. Remove Center Case Capscrews
14. Slowly and carefully begin to pry center case assem-
bly, cylinder block, and motor shaft up from transaxle
housing. The piston assembly is spring loaded and
must be held firmly to prevent damage.
NOTE: Use caution not to damage cylinder block or cen-
ter case. If either is damaged, center case, pump cylin-
der block and motor cylinder block should be replaced as
a set.
Figure C–28. Pry Center Case Upward
To Next Page
Loading...
Need help?
General
