13 GB/IE
2
Hold the thread in your fingers, guide it between the two tensions discs,
then pull it downward so it is seated correctly between the tension
discs (3).
Turn the hand wheel toward you until the lower looper is all the way to
the right.
Thread the thread guides 4-7 inside the looper compartment according
to the yellow markings.
Note: Using the tweezers inside the accessory box will make the looper
easier to thread.
Hold the thread with the tweezers approx. 4 cm from the thread
guide (7).
With the tip of the tweezers, slightly insert it under the thread guide (8)
from left to right.
Pull the thread up into the thread guide (8).
Feed the thread to the back and over the upper end 9-A of the left
looper.
Then carefully pull the thread down so it slips into the opening 9-B of the
looper.
Insert the thread into the looper eye (10).
Note: Using the tweezers inside the accessory box will make threading
easier.
The thread should run through the groove of the lower looper.
Pull approx. 10 cm of thread through the looper and place it over the
upper looper and toward the back.
Threading the right needle (green)
Thread the right needle in the order 1–8 as illustrated.
Insert the thread through the thread guide (1) from back to front.
347907_BE 13 24-Apr-2020
To Next Page
Loading...
Need help?
General
