19
Getting Started
Step 2: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack (L series) with the supplied
Charger.
b Notes
• You can use a large capacity battery pack, NP-
F770 (supplied) or NP-F970 (sold separately),
with your camcorder. You cannot use NP-F570.
1 Set the mode switch to CHARGE.
2 Connect the power cord (mains
lead) to the Charger and the wall
outlet (wall socket).
3 Place the battery pack in the slot
of the Charger, press it down, and
slide it in the direction of the
arrow.
The charge lamp turns on and charging
starts.
After charging the battery
The charge lamp turns off (normal charge).
If you continue charging 1 more hour after
the charge lamp turns off, you can use the
battery a little longer (full charge).
Remove the battery pack from the Charger
when the charge is completed.
To attach the battery pack
Press the battery pack against the back of
your camcorder and slide it in the direction
of the arrow.
z Tips
• You can check the remaining battery life with
the status check function (p. 71).
Power cord
(mains lead)
To the wall outlet
(wall socket)
Charge lamp
Mode switch
Charger
Continued ,
To Next Page
Loading...
Need help?
General
Weight and Dimensions
