Sony STR-DH590 Help Guide

Help Guide
MULTI CHANNEL AV RECEIVER
STR-DH590
Outputting a test tone from each speaker “T. TONE”
You can output a test tone from each speaker in sequence.
This operation is only available using the display panel on the front of the receiver.
Hint
To adjust the level of all speakers at the same time, press
+/–. You can also use MASTER VOLUME on the receiver.
The adjusted value is shown on the display panel during adjustment.
Related Topic
List of settings that can be adjusted using the menu on the display panel
4-731-210-11(1) Copyright 2018 Sony Corporation
Press AMP MENU.
1
Select “<LEVEL>” - “T. TONE” on the display panel.
2
Select the setting you want.
OFF
AUTO XXX (*): The test tone is output from each speaker in sequence.
If you need to adjust the speaker level according to the results of outputting a test tone, refer to “Adjusting the
speaker level [Level]” for how to adjust the level.
3
XXX represents a speaker channel (FL, CNT, FR, SR, SL, SW). The speaker channels that appear on the display panel vary depending
on the speaker pattern settings.
*
58

Sony STR-DH590 Specifications

General

Receiver type	Surround
Output impedance	6 - 16 Ω
Audio output channels	5.2 channels
Power output per channel (1KHz@6 Ohm)	145 W
Power output per channel (20-20KHz@8 Ohm)	- W
HDMI in	4
Digital audio optical in	1
Headphone connectivity	6.3 mm
Speakers connectivity type	-
Bluetooth	Yes
Ethernet LAN	No
Supported radio bands	FM
Preset stations quantity	30
HDCP version	2.2
Product color	Black
Audio decoders	DSD, DTS 96/24, DTS-HD HR, DTS-HD Master Audio, Dolby Digital, Dolby Dual Mono
Consumer Electronics Control (CEC)	BRAVIA Sync
AC input voltage	120 V
AC input frequency	60 Hz

Weight and Dimensions

Depth	297 mm
Width	430 mm
Height	133 mm
Weight	7100 g