Help Guide
MULTI CHANNEL AV RECEIVER
STR-DH590
Setting the HDMI audio signal output of connected devices “AUDIO.OUT”
You can set the HDMI audio signal output of playback devices connected to the receiver via an HDMI connection.
This operation is only available using the display panel on the front of the receiver.
Note
Audio signals are not output from the speaker of the TV when “AUDIO.OUT” is set to “AMP”.
When “TV+AMP” is selected, the sound quality of the playback equipment depends on the TV’s sound quality, such as the
number of channels, and the sampling frequency, etc. If the TV has stereo speakers, the sound output from the receiver is also in
stereo as that of the TV, even if you play back multi channel source.
When you connect the receiver to a video device (projector, etc.), sound may not be output from the receiver. In this case, select
“AMP”.
When you select “TV+AMP,” only sound from the HDMI IN jacks is output from the speaker of the TV.
Related Topic
List of settings that can be adjusted using the menu on the display panel
4-731-210-11(1) Copyright 2018 Sony Corporation
Press AMP MENU.
1
Select “<HDMI>” - “AUDIO.OUT” on the display panel.
2
Select the setting you want.
AMP: HDMI audio signals from playback devices are only output to the speakers connected to the receiver.
Multi-channel sound can be played back as it is.
TV+AMP: The sound is output from the speaker of the TV and the speakers connected to the receiver.
3
To Next Page
Loading...
Need help?
General
Weight and Dimensions
