Sony STR-DH590 Help Guide

Help Guide
MULTI CHANNEL AV RECEIVER
STR-DH590
Updating the software “UPDATE”
Before updating, visit the customer support website to download the latest software version to your USB flash drive.
This operation is only available using the display panel on the front of the receiver.
Note
It may take about 15 minutes for the update to be completed.
Do not turn the receiver off while the software is being updated. It may cause a malfunction.
You cannot restore the old version after updating the software.
Related Topic
Customer support websites
List of settings that can be adjusted using the menu on the display panel
4-731-210-11(1) Copyright 2018 Sony Corporation
Connect the USB flash drive to the POWER SUPPLY port on the rear of the receiver.
1
Press AMP MENU.
2
Select “<SYSTEM>” - “UPDATE” on the display panel.
3
Select “START”.
“READING” will flash, and then “UPDT xxx” (*) will appear on the display panel. When the update is completed,
“COMPLETE” appears on the display panel and the receiver restarts automatically.
4
“xxx” represents a percentage of the update that is completed.
*
79

Sony STR-DH590 Specifications

General

Receiver type	Surround
Output impedance	6 - 16 Ω
Audio output channels	5.2 channels
Power output per channel (1KHz@6 Ohm)	145 W
Power output per channel (20-20KHz@8 Ohm)	- W
HDMI in	4
Digital audio optical in	1
Headphone connectivity	6.3 mm
Speakers connectivity type	-
Bluetooth	Yes
Ethernet LAN	No
Supported radio bands	FM
Preset stations quantity	30
HDCP version	2.2
Product color	Black
Audio decoders	DSD, DTS 96/24, DTS-HD HR, DTS-HD Master Audio, Dolby Digital, Dolby Dual Mono
Consumer Electronics Control (CEC)	BRAVIA Sync
AC input voltage	120 V
AC input frequency	60 Hz

Weight and Dimensions

Depth	297 mm
Width	430 mm
Height	133 mm
Weight	7100 g