SPEAKERS
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
7:
Selecting
the
speaker
system
Insertingbatterie~
,i~~J'"
•..
_,y,y,
remot~~,~''''''
.'
', \
Insert two
R6
(size-AA) batteries in the
RM-AAU021 Remote Commander.
Observe the correct polarity when installing
batteries.
*
To
select
"SP
B", set "SB ASGN"
to
"SPK
B"
in
the System settings menu (page 43).
Press SPEAKERS repeatedly to
select the front speaker system
you want to drive.
Notes
• Do not leave the remote in
an
extremely hot
or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds
of
batteries.
• Do not expose the remote sensor to direct sunlight
or
lighting apparatuses. Doing so may cause a
malfunction.
• [f you do not intend to use the remote for an
extended period
of
time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings.
If
this
happens, reassign the buttons again (page 96).
• When the remote no longer operates the receiver,
replace all the batteries with new ones.
To select
The front speakers connected to the
SPEAKERS FRONT A terminals
The front speakers connected to the
SPEAKERS SURROUND BACKI
BI-AMP/FRONT B terminals
The front speakers connected to both
the SPEAKERS FRONT A terminals
and SPEAKERS SURROUND
BACKlBI-AMP/FRONT B terminals
(parallel connection)
Light up
SPA
SP
B*
SP A and
SP
B*
To tum off the speaker output, press
SPEAKERS repeatedly until the "SP A" and
"SP
B" indicators on the display light off.
Note
You cannot switch the front speaker system by
pressing SPEAKERS when the headphones are
connected to the receiver.
30
US
To Next Page
Loading...
Need help?
General
Weight and Dimensions
