397
Setting Regions Selected
Simultaneously
You can set the regions that are selected simultaneously
when using the [All Regions] button in the effect timeline
and snapshot menus or the [ALL] button in the numeric
keypad control block.
1
Open the Home > Setup > Panel > Config > All
Regions Assign menu (19104.12).
2
Select the target region to set.
To select and set multiple regions, pl
ace a check mark
beside the target regions to set.
To select and set all regions, place a check mark in the
Sel
ect All checkbox.
3
Set the [Assign] switch to the on state.
Assigning Control Panel
Buttons
Assigning Buttons (ICP-X7000)
You can select the functions to assign to the assignable
buttons of each control block in the control panel.
You can also set to inhibit operation in the key fader
co
ntrol block and key control block.
Assigning a function to an assignable
button
1
Open the Home > Setup > Panel > Module > Button
Assign menu (19104.21).
An image of the entire control panel appears.
Each control block is enclosed by a white frame.
2
Press within the white frame of the target control
block to set.
An enlarged image of the se
lected control block
appears.
The assignable buttons are di
splayed in white and the
button name of the currently assigned functions are
displayed.
To return to the entire display
Press the [Back] button.
For a cross-point control block/AUX bus control
bl
ock
Select a cross-point control block or AUX bus control
block to display the Home
> Setup > Panel > Xpt
Module > Xpt Pad Button Assign menu (19104.36).
Set the cross-point pad buttons and pages.
For details, see “Setting a Cross-Point Pad”
(page 405).
For a numeric keypad control block
You can assign up to four regions (1 to 4) to an
assignable
button (region selection button). Set a
region for each region number (1 to 4).
For details, see “Assigning regions to a region
selection button in the numeric keypad control block”
(page 398).
For a key fader control block
You can set assignable buttons (key delegation
buttons) and the fader lever
.
For details about setting the fader lever, see “To set
the fader lever in a key fader control block”
(page 398).
To Next Page
Loading...
Need help?
General
