450
3
Enter the date and time.
Enter values in the order year (YYYY), month (MM),
day (D
D), hour (hh), minute (mm), and second (ss).
4
Press [Enter].
Setting the switcher to act as an NTP
server
When the switcher is configured to act as an NTP server,
an external device connected to the switcher can access
the NTP server.
1
Open the System Configuration > Date/Time > Date/
Time Settings menu (20301.11).
2
Set the [NTP Service for Ext Dev] button to the on
state.
To deny access, set the [NTP Service for Ext Dev]
bu
tton to the off state.
Firmware Version
Management and
Installation
Displaying Package Status
You can check information about the installed packages
in the System Configuration > Version > Info/Install
menu (20401.11).
Current System Version: Installed package version
Status: Version status within a package
“OK” is displayed if there is no mismatch.
“ Incorrect Version” is displayed if t
here is a
mismatch.
The following information is displayed for each switcher/
co
ntrol panel.
Select a tab to change the switcher (Switcher)/control
pan
el 1 (Panel 1)/control panel 2 (Panel 2) display.
Module: Name of module within the switcher/control
pan
el
Version: Version of module
Date/Time: Modification date and time of module
The display of modification date and time may not be
su
pported depending on the module.
Installing a Package
Repairing a package mismatch
1
Open the System Configuration > Version > Info/
Install menu (20401.11).
2
Press the [Recover] button.
3
Check the message, then press [OK].
The switcher system reboots.
Once the process has starte
d, it cannot be undone.
Installing a package
Administrator privileges are required for package
installation operations.
1
Open the System Configuration > Version > Info/
Install menu (20401.11).
Note
Note
To Next Page
Loading...
Need help?
General
