Suzuki drz 400 2000 User Manual

Remove the wheel bearings as follows:
• Remove the wheel hub dust seal. (c::::r 6-6)
• Insert the bearing remover a tt achment CD into the wheel bear-
ing.
• Insert the wedge bar ® from the opposite side and lock it into
the slit of the bearing remover attachment.
• Dri ve out the wheel bearing by striking the wedge bar.
I§b 09941-50111 : Bearing remover
I A CAUTION ]
Replace the removed bearings with new ones.
FRONT WHEEL
Make sure that the wheel runout (axial and radial) does not ex-
ceed the service limit when checkeu 0::5 :::;11QWr1. All excessive
amount of runout is usually due to worn or loose wheel bearings
and can be corrected by replacing the bearings. If bearing re-
placement fails to reduce the runout, replace the wheel wi th a
new one.
_ Wheel rim runout (axial and radial)
Service Limit : 2.0 mm (0.08 in)
FRONT AXLE
Measure the front axle runout using the dial gauge. If the runout
exceeds the service limit, replace the front axle with a new one.
S! 09900-20606: Dial gauge (1 1100 mm)
09900-20701 : Magnetic stand
09900-21304: V- block set (100 mm)
~ Wheel axle runout
Service Limit : 0.25 mm (0.010 in)
TIRE .......... .. ............. _ .................... .. ............ c::::r 2-21 and 2-22
SPOKE NIPPLES ........................ .. .................... .. ....... c::::r 2-22
CHASSIS 6-7
2
http://www.motorcycle.in.th

Suzuki drz 400 2000 Specifications

General

Brand	Suzuki
Model	drz 400 2000
Category	Motorcycle
Language	English