• T
ig
ht
en
the crankcase bolts
to
the specified torque.
~
Crankcase
bolt
:
11
N·m
(1
.1 kgf-m, B.O Ib-
It
)
• After the crankcase boits have been tightened, check if the
crankshaft, counters haft, and driveshaft rotate
smoothly.
If
a
large resistance IS leI! to rotation , try
to
free me snafts
by
tapping them with a plastic mallet.
STARTER
CLUTCH
AND
GENERATOR
ROTOR
• Remove the grease from the tapered portion 01 tne c
ranK-
shaft and the generator rotor.
• Install the starter clutch gear
Q)
and
key
(1)
.
• Tighten the generator rotor nut to the specifi
ed
torque using a
26
mm
offset wrAnr.h
~Generator
rotor
nut:
100 N·m (10.0
kgf
-m, 72.5 Ib-
It)
ENGINE 3-
51
http://www.motorcycle.in.th
To Next Page
Need help?
General
