6-
38
CHASSIS
SWINGARM
Inspect
the swingarm for damage.
If
any damages are found,
replace the swingarm with a new one.
CUSHION LEVER NEEDLE BEARINGS
Insert
the spacers into the needle bearings, move the spacer
up
and down and check for any
play.
If
there
is
excessive
play,
re-
place
the bearings with new ones.
• Remove the cushion lever needle bearings using the special
tools.
CiI 09923-73210: Bearing remover
09930-30102:
Sliding
hammer
I A
CAUTI
QI\j]
Replace
the
removed needle
bearings
with
new
ones
.
CUSHION
LEVER
AND
CUSHION
LEVER
RODS
Inspect
th
e cushion lever and cushion lever rods for damage.
If
any damages are found, replace the cushion lever and cushion
lever rods with
new
o
nes
.
PIVOT SHAFT
Measure the pivot shaft runout using the dial gauo"-
If
thp.
rt
mnllt
exceeds the service limit, replace the pivot shaft.
CiI 09900-20606: Dial
gauge
(1/100
mm)
09900-20701 : Magnetic stand
09900-21304: V-block set (100
mm)
~
Swingarm
pivot
shaft
runout
Service
Limit:
0.3
mm
(0.01 in)
http://www.motorcycle.in.th
To Next Page
Loading...
Need help?
General
