5-42 CHASSIS
• Tighten the brake caliper mounting bolts 1 and brake hose union
bolt 2 to the specified torque.
%%
%%
% Brake caliper mounting bolt 1: 39 N
.
m (3.9 kgf-m)
Brake hose union bolt 2: 23 N
.
m (2.3 kgf-m)
NOTE:
Before remounting the brake caliper, push the brake caliper pis-
tons all the way into the caliper.
"
Bleed air from the system after reassembling the brake
caliper. (
&&
&&
& 2-16)
BRAKE DISC INSPECTION
Check the brake disc for damage or cracks. Measure the thick-
ness using the micrometer.
Replace the brake disc if the thickness is less than the service
limit or if damage is found.
!!
!!
! 09900-20205: Micrometer (0 – 25 mm)
##
##
# Brake disc thickness
Service Limit (Front): 4.0 mm
(Rear): 4.5 mm
Measure the runout using the dial gauge.
Replace the disc if the runout exceeds the service limit.
!!
!!
! 09900-20606: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
##
##
# Brake disc runout
Service Limit (Front and Rear) : 0.3 mm
To Next Page
Loading...
Need help?
General
