ELECTRICAL SYSTEM 6-23
Apply 12 volts to terminals A and B, and check the continuity
between the positive and negative terminals.
If the starter relay clicks and continuity is found, the relay is OK.
!!
!!
! 09900-25008: Multi circuit tester set
""
""
" Tester knob indication: Continuity test (
##
##
#)
Check the relay coil for opens, grounds and the specified resis-
tance.
$$
$$
$ Starter relay resistance
Standard: 3 – 5
ΩΩ
ΩΩ
Ω
SIDE-STAND/IGNITION INTERLOCK SYSTEM
PART INSPECTION
If the interlock system does not operate properly, check each
component. If any abnormality is found, replace the component
with a new one.
NEUTRAL SWITCH
The neutral position indicator switch coupler is located under the
fuel tank.
• Remove the seat. (% 5-2)
• Remove the fuel tank. (% 4-3)
• Disconnect the neutral position indicator switch coupler and
measure the continuity between Blue and Ground with the trans-
mission in neutral.
&
Do not apply battery voltage to the starter relay for more
than five seconds.
This may overheat and damage the relay coil.
To starter motor -
+ To battery
Blue Ground
ON (in neutral)
OFF (not in neutral)
To Next Page
Loading...
Need help?
General
