25
Front / Rear Brake Pad Inspection:
Inspect the brake pad wear of both front and rear disk brake ○,
B
caliper ○,
A.
If any pad lining thickness reaches the minimum thickness line ○,
a,
have the brake pads replaced by an authorized SYM dealer.
Throttle Free Play Inspection
Check that the throttle grip moves smoothly from full open to close.
Check that there is 5°~ 10° ○,
A of throttle free play when turning the throttle
grip back and forth.
Have the throttle free play checked by an authorized SYM dealer.
Tire / Tire Pressure Inspection
Remove the air valve cap ○,A.
Measure the tire pressure often and inflect the tires to the
recommended tire pressure.
Visually inspect the tire for cracks and cuts, replace the tires
when necessary.
Measure the depth of the tread, replace the tire that has worn
down to the minimum allowable tread depth.
Recommended tire pressure
Front: 1.8 kgf/cm
2
Rear: 2.3 kgf/cm
2
WARNING:
• Use only DOT 4 brake fluid.
• Brake fluid is easy to absorb moisture from the air, any absorbed moisture will reduce the braking
efficiency greatly.
• Contact an authorized SYM dealer immediately if any brake fluid leakage is found.
NOTE :
• Brake pads must be always replaced as a set.
•
New brake pads require a break-in period.
WARNING:
• Insufficient tire tread depth can make the motorcycle difficult to control.
• Please refer to the local regulations about tire tread depth.
• New tires are slippery and may cause loss of control.
○,A
○
a
○,B
○,A
○,A
To Next Page
Loading...
Need help?
General
