27
Rear Shock Absorber Adjustment
This scooter is equipped with 2 rear shock absorbers ○,A. Each shock absorber has 4 positions for spring
preload adjustment. The standard position is 2.
Turn the adjuster ○,
B anti-clockwise ○,a to increase preload (hard).
Turn the adjuster clockwise ○,
b to decrease preload (soft).
Contact your SYM dealer for adjustment.
10. Diagnosis When Engine Does Not Start
NOTE :
• Make sure to keep the dust from entering the inlet pipe during inspection.
• Use SYM genuine air filter element to ensure the engine performance.
NOTE :
• Do not exceed the adjuster’s limit.
(1).Has the ignition switch key
been turned to “ON”
position?
(2).Is there enough fuel in the fuel
tank or the
is in the “E” position?
(3).Is the rear or front wheel
brake
start button?
(4).Check that the engine stop
switch is in the
“ ”position or not?
(5).Turn the ignition switch key
“ON”, and press horn butt
on
down, if the horn does not
sound, the fuse may have
been blown.
(6).Remove the front body cover
to check the fuse box, if the
wire is obvious melted,
replacement is needed.
○,A
○
a
○
b
○,B
To Next Page
Loading...
Need help?
General
