2-52
CONTROLS
HIGH-FLOW HYDRAULIC SYSTEM
(IF EQUIPPED)
Note that the high-output type brush
cutter attachment can be used only if it is
equipped with the easy brush-cleaning
function and the proper cooling system,
for a short period of time at a moderate
ambient temperature.
Pay careful attention not to damage the
undercarriage when using such
attachment. These precautions also apply
to any other high-performance and/or
highly functional attachment.
IMPORTANT: Running the high flow
hydraulics for extended periods of time
could cause damage to the hydraulics or
other systems of the machine due to
overheating.
To prevent overheating and reduce the
risk of fire, the machine should be
cleaned daily.
The standard cooling package is not
permitted for use in high airborne debris
applications such as mulching mower or
land clearing.
IMPORTANT: Do not operate the machine
in the detent mode for a long time. Doing
so will increase the hydraulic oil
temperature and shorten the service life
of the hydraulic units.
This high-flow system is designed to provide
the specific attachments that require a large
volume of oil, such as snow removing
equipment and lawn mower, with sufficient
oil in one-way.
Flow rate . TL8: 128 L/min* (33.8 US gpm*)
TL10: 142 L/min* (37.5 US gpm*)
TL12: 153 L/min* (40.4 US gpm*)
*: The flow rate can be changed.
Refer to “3. Auxiliary 1st-1 setting
information” on pages 2-18 to 2-19.
ACCESSORIES
1. Turn on the high-flow switch (lamp lights
up).
The symbols on the instrument cluster and
the display light up. (If an attachment has
been connected to the auxiliary piping.)
Operating the high-flow system
<TL8>
<TL10/TL12>
To Next Page
Loading...
Need help?
General
