2-15
CONTROLS
INDICATORS
8. Glow lamp
This lamp goes out when the engine
preheating is completed.
9. Power mode indicator lamp
This lamp lights up when the Power mode
side of the ECO/Power mode select
switch is pressed. The maximum engine
output is maintained for as long as this
lamp is lit.
10. ECO mode indicator lamp
This lamp lights up when the ECO mode
side of the ECO/Power mode select
switch is pressed. The machine drives
with reduced RPM for lower fuel
consumption, without compromising
workability.
11. Travel speed lamp
This lamp turns on when the travel speed
button is set to the 2nd (high) speed.
12. Arm float indicator lamp
This lamp light up when the float button
is pressed to set the lift arms to the float
mode.
13. Auxiliary 1st flow rate indicator lamp
This lamp lights up to indicate which flow
rate setting is selected in the auxiliary
1st.
1 ....... Flow rate setting 1
2 ....... Flow rate setting 2
3 ....... Flow rate setting 3
14. High-flow indicator lamp
Lights up while the high-flow is
functioning.
INSTRUMENT CLUSTER
METERS
15. Water temperature gauge
Indicates the temperature of the engine
coolant water.
The LED should be within the green
range during machine operation.
The red range indicates overheating.
16. Fuel Gauge
Indicates the amount of fuel in the tank.
When the fuel level becomes low, the
bottom LED bar flashes eight times, and
then the flash cycle is performed twice.
Flash cycle: LED bars turn on in
succession from the bottom to the top,
and then turn off in succession from the
top to the bottom.
Be sure to top off the tank before running
out of fuel.
To Next Page
Loading...
Need help?
General
